Skip to main content

On deck again

 Saturday

Jon went to the cabin to prep more. Offloaded half the tile.


Did a dump run to clear cabinet boxes out of storage.


I finished up the big slab.


I made a jig to drop the post bases into the columns exactly in the right place.


Sunday

I made a jig for the other columns.


I made another little slab for the other side of the entry.


I tidied up inside, including making a countertop to move tools onto. Not many unfinished surfaces left!


Wednesday

The concrete truck arrives today! We only need about a yard, but the choices were mixing sixty bags ourselves, driving to Yakima for a 3/4 yard rental trailer, or paying for the three yard minimum from the truck.

While we waited, Siggy and I got started on a temporary gate support to replace the previous temporary gate post that's falling over.


Truck's here! Let's fill these slabs.



And these columns.


Well we have a lot of leftover concrete in this wheelbarrow. Dad can I make my own form?


Everything cooking.


We finished up the gate post replacement before we headed home.












Comments

Post a Comment

Popular posts from this blog

The trim finishing journey begins

The last time we installed wood trim (almost two years ago!), we sanded and cut the material inside the cabin (it was winter) and installed it unfinished. Finishing it meant taping everything off and applying three coats of finish in place. Removing the masking was frustrating (the finish glued it to the wall in places), and in other places the finish still got where it didn't belong. Now the cabin is full of nice, finished floors, cabinets, and counters. It's not a shop. So this time, I'm sanding and pre-finishing all the boards outdoors. Thankfully, there's still pretty nice weather; that black tarp garage heats up pretty well when the sun's out. Today I got the first batch of wood sanded and a coat of finish applied. Christina installed eight receptacles in the kitchen and great room. My mom came up to enjoy the warm ambiance of the not-yet-active wood stove.
1 comment
Read more

Uncrating the wood stove

  I drove up to the cabin today to meet a tree contractor. Since I was up there anyway, I took care of some other business. I got the wood stove out and ready to install on Monday. I vacuumed up the tiny particles of styrofoam packaging material from last year's roofing panels that would have been much easier to clean up last year. I put the bathroom outlet back into its adjusted place above the backsplash. I corrected my installation of the heat pump wiring with a pair of reducing washers. Now it's really done. I replaced the emergency brake battery system in the flatbed trailer.  I bucked a bunch of old logs into rounds for firewood.
Post a Comment
Read more

Odds and ends

I made progress on a bunch of little things today.  I painted a fencepost in 12" segments and pounded it in at the property line, where the outdoor camera can see it. Now we can measure the snow accumulation. I worked on finishing up almost-complete receptacle branch circuits. The first one I worked on was a little mystery: all the receptacles were installed, but the power didn't reach past a certain point in the line. After some investigation with a wire tracer and watching through the videos we took before covering the walls, I worked out what had happened: two receptacles shared a stud bay, facing into opposite rooms. The plan had been to bring power up to one box, jump over to the other box, and continue back down to the crawlspace to the next box. We forgot the jumper. I couldn't fish a wire between the boxes myself, so that repair waits. Upstairs, installing two receptacles completed the branch. The bathroom vent hole in the tile backer board was a skosh too small. ...
Post a Comment
Read more