Skip to main content

Back at it

Eliot and I were back up at the cabin this weekend. We made and installed two more pieces of the tricky trim on the front of the house.



Getting these to fit right takes a surprising amount of test fitting and adjustment. There's getting the visible dimensions correct, then removing material on the back to clear various lumps from the nailing flanges. Then we use Bondo to fill gaps on the surface, sand, and prime the board. Finally, we have to mask the windows and caulk them on the way in.





We also installed ledger boards under all the doors; this is what the decks will mount to. These need metal flashing to keep water out of the gap between the board and the house.


Siggy did a little of his own construction.


We also worked on some of the electrical branch circuits.
Eliot's cutting a hole in a shear wall for the range outlet.

Punching out holes for the water heater cables to enter the panel.

Fitting the water heater to the wall in the closet. We have a 36kW tankless electric heater, which is basically a really big 1.6Ω resistor. Our electrician thinks it's ridiculous, and he's probably right.

All told for the weekend, we installed two pieces of trim, three ledger boards with flashing, and five electric cables for the water heater and dryer.

Boy this place looks cozy at night!

Comments

Post a Comment

Popular posts from this blog

The trim finishing journey begins

The last time we installed wood trim (almost two years ago!), we sanded and cut the material inside the cabin (it was winter) and installed it unfinished. Finishing it meant taping everything off and applying three coats of finish in place. Removing the masking was frustrating (the finish glued it to the wall in places), and in other places the finish still got where it didn't belong. Now the cabin is full of nice, finished floors, cabinets, and counters. It's not a shop. So this time, I'm sanding and pre-finishing all the boards outdoors. Thankfully, there's still pretty nice weather; that black tarp garage heats up pretty well when the sun's out. Today I got the first batch of wood sanded and a coat of finish applied. Christina installed eight receptacles in the kitchen and great room. My mom came up to enjoy the warm ambiance of the not-yet-active wood stove.
1 comment
Read more

Uncrating the wood stove

  I drove up to the cabin today to meet a tree contractor. Since I was up there anyway, I took care of some other business. I got the wood stove out and ready to install on Monday. I vacuumed up the tiny particles of styrofoam packaging material from last year's roofing panels that would have been much easier to clean up last year. I put the bathroom outlet back into its adjusted place above the backsplash. I corrected my installation of the heat pump wiring with a pair of reducing washers. Now it's really done. I replaced the emergency brake battery system in the flatbed trailer.  I bucked a bunch of old logs into rounds for firewood.
Post a Comment
Read more

It is DONE!

The final inspection was today. This guy is Levi, the county inspector, and as you can see, we passed! He only had two questions for me. One was about the energy efficiency credits and the blower door test, for which I had the compensating paperwork for the low-flow faucets already prepared. The second was asking for a smoke detector outside the bedroom; I pointed up and he saw that we already had one tucked into the alcove. And that was that! I got up at 5am to be certain I'd be here before the inspector, and I was ... by about five hours. In that time, I took another truckload of tool buckets down to the storage container, then picked up all the floor protection in the great room and vacuumed and mopped. It's glowing! Then I went back down to the storage container to get a hammer so I could glue in 32 wood plugs to cover the screws for the french doors. I fought with installing the screens, but the frames are too big! The manufacturer said "yeah we don't even make th...
Post a Comment
Read more